Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.

0 Answers   HAL,

---

how to reduce the transformer size in ups ?

2 Answers  

---

Details about Flux Compensated magnetic Amplifer starter for motors

0 Answers  

---

What is thyristor?

13 Answers  

---

What is the technical difference between IS:1554 and Indian Railway IRS:S63/2007

0 Answers   Indian Railways,

---

---

whye the current increases in the motor when the load on the motor increases

3 Answers  

---

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its secondary is kept open circuited, then the bulb would have (1) Full brightness (2) Poor brightness (3) A little less than full brightness (4) More than full brightness...explain

2 Answers  

---

Define open loop control system.

0 Answers  

---

how much power consumed by 1.5 ton capacity split A.C in 1 hour

2 Answers  

---

what happens if number of poles in stator and rotor windins of slip ring induction motor are not same. Will it rotate near to the synchronus speed defined by stator?

1 Answers   GATE,

---

A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is

0 Answers  

---

What is protection for single phasing ?

6 Answers   SISL,

---