Interested to Buy Any Domain ? << Click Here >> for more details...
please give me combustion cntrl interlock details? if
possidle drawing also?for this one is there any website ?
- 1 Answers
- 4129 Views
- I also Faced
- E-Mail Answers
Answer Posted / yashwant
FIRST INTERLOCK SHOULD BE FURNACE PRESSURE(IT WILL BE 0-50
MMWC)WHICH WILL BE APPLIED TO ID, FD, SA,GA ANY TRIPPING CKT.
SECONDLY VERY HIGH TEMPERATURE/PRESSURE. OTHERS ARE FEED WATER
LEVEL, FUEL QTY ETC
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
flow transmitter formula?
Explain PID controller tuning & any one method used for it.
can you send remote seal interface level transmitter calculation steps for oil water saperator.
which type of zones used for boiler? & why ?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
how to turbine speed measurement?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
Pl send the model question paper of mahagenco account officer post
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
What is the reason PT speed not incresed in gas turbine?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Why do we floating DC in DC system.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
