Answer / kyle condran

Zener diodes regulate voltage. when placed in reverse bias is will have a constant voltage across it's terminals.

place it in parallel with a load and the load will receive a constant voltage regardless of the current flowing in the circuit as long as there is enough current to drive the diode.

since any parallel circuit will have the same voltage dropped across each parallel leg.

it does not act like a battery, the only component that acts like a battery is a capacitor, in that it can hold a voltage potential, but does not have much staying power when driving a current.

Answer / santoshkosuru

a zener diode is like normal forward biased diode the thing is
that it acts like a battery in the breakdown region.

you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.

0 Answers   DEWA,

---

what are the programming languages used in dcs

7 Answers  

---

applications of 1-5v and 4-20ma?

4 Answers  

---

What is the formula To convert Degree centigrade to foranhight.

5 Answers  

---

What is the difference between PLC-HMI and DCS as each function of DCS based system is possible in PLC ?

2 Answers   Lucky Cement,

---

What is the definition of direct acting valve & reverse acting valve

2 Answers  

---

wht is mean by dpt(differential pressure transmitter)

1 Answers  

---

A pressure transmitter with a range of 0-100 bar.The accuracy of the instrument is 1% of upper range value? The pressure indicating transmitter is showing the system pressure is 50 bar. b. When you include the error, what is the minimum possible pressure in our fuel gas system? i. 49.5 bar ii. 49 bar iii. 1 bar iv. 0.5 bar We want to change the filter cartridge. We must depressure the fuel gas system. c. After we depressure the system in preparation for maintenance, the transmitter displays a pressure of +0.1 bar. At this time, what is the possible range of pressures in our fuel system? i. +0.099 to +0.101 bar ii. 0 to +0.2 bar iii. -0.1 to +0.3 bar iv. -0.9 to +1.1 bar

3 Answers  

---

Pls.could any one Clarify the following with an example. 1.At What condition Close on Rise and Close on Fall Pressure Switch contacts are used. 2.If Pressure is abnormal as per set pressure,if connecting Terminal of pressure switch breaks,how the voltage extends to Relay base. 3.Are these contacts come under fail safe philasaphy.

1 Answers  

---

I want to measure bidirectional steam flow? Kindly suggest me a suitable flow meter. steam is superheated at 41kg/cm2, 350°C

2 Answers  

---

I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?

0 Answers   SRAAC,

---

why we are using ungrounded RTD sensor and what is difference between grounded RTD and Ungrounded?

1 Answers  

---