Answer / ankamsreekar

In AC the voltage mentioned is RMS value. the RMS value is
the product of Form factor and average value. the Form
factor for the sine wave is 1.11. so all the voltages are
multipliers of the factor 1.11.

EX in Alternator E(rms)= 4.44*Kd*Kp*Flux*HZ*RPM

Answer / ankur

Vrms=Vpeak/sqrt(2)
Vavg=(2/pi)*Vpeak
Vpeak=(pi/2)*Vavg
so,
Vrms=(pi/(2*1.414))*Vavg
to get a average of 100Volt
the rms comes to be a multiple of 111V
so all voltages are multiple of 1.11
@Sonal: even 132 is 12*11

Answer / sonal

BUT how is 132 a multiple of 1.11. plz help

Answer / guest

In AC the voltage mentioned is RMS value. the RMS value is
the product of Form factor and average value. the Form
factor for the sine wave is 1.11. so all the voltages are
multipliers of the factor 1.11.

EX in Alternator E(rms)= 4.44*Kd*Kp*Flux*HZ*RPM

Answer / anonymous

Bcoz there is a
loss of 10%
while
transmission of
current through
cable lines. So
instead of
transmitting
current in
multiples of 10,
its 10% extra is
transmittd dat
is in multiples
of 11 in order
to compensate d
loss.

can we use ELCB and RCBO in one db

6 Answers  

are there rmu for 3 transformer?

0 Answers   OSC,

What is the Diference between DYN 11 and DYN 5 .How to change the Vector group from DYN 11 to DYN 5.

3 Answers  

why the measure taken in multiplication factor of 11for voltage like.. 110V,220V,440V,1.1KV,6.6KV,11KV,33KV,66KV,110KV,132KV,220KV

1 Answers   Vijai Electricals,

what is b checks and m checks in diesel generator maintenance?

1 Answers  

we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain

0 Answers   TNEB Tamil Nadu Electricity Board,

Pl. share your experience about industrial-electronics repair of machine tool.

0 Answers  

what is meant by reactive power ?

5 Answers  

Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.

0 Answers  

how to setting voltage RTCC panel

0 Answers  

Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?

0 Answers   Honda,

what are safety measures in /control in diesal engine/ explain them?

0 Answers