Interested to Buy Any Domain ? << Click Here >> for more details...
Why voltge arev transformed in to 132KV/66/KV/33KV like
that
- 5 Answers
- 9543 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / ankamsreekar
In AC the voltage mentioned is RMS value. the RMS value is
the product of Form factor and average value. the Form
factor for the sine wave is 1.11. so all the voltages are
multipliers of the factor 1.11.
EX in Alternator E(rms)= 4.44*Kd*Kp*Flux*HZ*RPM
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
Define reserve-generating capacity?
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what is differant beetween overload current and phase current?
how to calculate the distance relay faulty zone?pls explain?
Can i use the B-curve MCB instead of C-curve MCB
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is notching in dc machine?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
how to extend relay operating timing in 24V dc relay card (without using Timer )
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
