Why voltge arev transformed in to 132KV/66/KV/33KV like
that
- 5 Answers
- 8365 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / guest
In AC the voltage mentioned is RMS value. the RMS value is
the product of Form factor and average value. the Form
factor for the sine wave is 1.11. so all the voltages are
multipliers of the factor 1.11.
EX in Alternator E(rms)= 4.44*Kd*Kp*Flux*HZ*RPM
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
The electromagnetic torque developed is proportional to what in a D.C series motor?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
why only exciting current is shown not primary current in transformer???
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
Can anyone tell the proper diagram of star delta starter????
2. What are the parameters of EHT sub-station?
What is meant by analogous system?
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
how can i improve the power factor in domestic (230v)
Define corner frequency?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
What is the difference between hot and cold loop testing?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
what is the purpose of silicon dropper used in battery charger?
