Answer / huzy

This relay continuously supervise the healthiness of tripping circuit.It gives an alarm for Open / short tripping coil or tripping supply failure.

Answer / raghavendran.r

I would like to add more on the previous answer.As stated
earlier trip circuit supervision relay will monitor the
proper functioning of trip circuits based on the feedback
signal obatained from the tripped circuit.if the circuit
has not tripped even after getting trip command,then as a
preventve measure sometimes LBB ie local breaker back up
will act upon to prevent any further damage to the system
due to any fault.

Answer / hanuman

trip circuit supervision relay is the relay which
supervises the trip circuit of the circuit breaker. It even
tests wheather dc supply to trip circuit is under proper
condition or not. some times trip circuit gives signal to
circuit breaker, but circuit breaker doesn't break the
circuit, then supervision relay makes circuit to break by
LBB.

Answer / k.prakashchandra

This relay is used to supervise the tripping circuit and to
provide alarm ,independent of breaker status, for 1)loss of
dc supply2)faults in trip coil or cables 3)faults on the
breaker aux contacts 4)faults in the relay itself

Answer / balaji

This Relay will monitor over All the tripping circuit's healthy condition and will provide alarm in tripping circuit unhealthy also Can be utilize multi level.

Answer / nitin bhati

as its name indicate ...it works like a supervisor used to control the complete tripping circuit if there is a fault in controlling supply (dc) it sense it and gives a command to breaker.

what is relay multiplier

1 Answers   Atomic Energy Commission, Bhel, Wipro,

Your B.tech marks is being given in CGPA grade. How is it calculated?

1 Answers  

why in large rating C.T.s equipotential wires are used?

2 Answers   Essar,

What is the function of trip neutral close switch?

11 Answers  

Hi, I'm running plastic reprocessing company where all motors are running only in delta. Due to that when I use start my 30 hp motor my transformer gets fuse. Where it happens two times a day. I gt a suggestion from a person about Automatic Power Factor Controller APFC. Is it useful for my problem??? Or is der any other way for solving this problem?? Upgrading the transformer is difficult. Pls give Me ur suggestion. Waiting for ur reply.

2 Answers   Shree Lingaa Polymer,

Why voltge arev transformed in to 132KV/66/KV/33KV like that

5 Answers   HAL,

V.c.b and a.c.b difference

4 Answers  

why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?

0 Answers  

what are the reasons for overheating in electrical machines?

3 Answers  

what about electrical pannel.? What is meant by plc pannel.?

0 Answers   TATA,

A motor works on 30 killo watts.how much ampers will be required if it works on 440volts?

5 Answers  

How can remove the jerks on genretor due to remov or connecting the load ?

3 Answers