Answer / shekar

By mounting a fly wheel to the shaft of generator

Answer / ravi_veer

By using speed governing system with steam turbines which
regulates the steam supply to the turbine and hence reduce
the load effects on the generator.

Answer / basheer ahmed

BY CONNECTING A STARTER i.e. A LARGE RESISTANCE IN SERIES
WITH THE GENERATOR AND IS ADDED IN STEPS.

A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.

0 Answers   VECL,

---

What is the clear distance between a MV panel(rear side) and wall.

3 Answers   L&T,

---

what is the equation of converting KW into HP ?

4 Answers  

---

What is difference between stable and steady?

1 Answers  

---

why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain

0 Answers   ISRO,

---

---

we the the value of frequency is 50 HZ in DG then why we said the value inductive rectance is zero in DG?

1 Answers  

---

If the rank of a (5x6)matrix Q is 4, then which one of the following statements is correct ?

1 Answers   GATE,

---

we have taken HV test of 2.5 k and Megger test on 11 kv HT cable.here it shows no fault but when we are charging the same cable with 11 kv supply why the VCB 11 kv gets tripped can anybody define the possible cause of fault ?

4 Answers   MAHINDRA,

---

what will happen if we double the input frequency of a transformer keeping the voltage constant?

6 Answers  

---

how current rating of l.t cable is find

2 Answers   GAIL,

---

H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....

0 Answers   Essar,

---

what is stper motor.what is its uses

9 Answers   Bhel, HCL,

---