Answer / jaswant rajawat

Bus earthing truck is use to earth bus bars of switchboard
at the time of maintenance of bus bars. For this we have to
remove incomer breaker panel and insert bus earthing truck
so that bus bars will remain earthed during maintenance.

Cable earthing truck is use to earth incoming cable or
outgoing feeder cable in switchboard during maintenance at
transformer end or motor terminal box.

Answer / bala.a

for saftey point of view and reduced to time for providing
Individual earthing system.

Answer / sounak chatterjee

In transmission and distribution lines the flow of of power depends upon mode of operation.There are two ways ,one from importing power from grid system,and the other one is exporting power to grid. There are certain switchboards whose sole application is to deliver power from system and as well as importing power from the system. In case of only importing only bus side earthing truck will suffice the purpose but in case of dual operation cable side earthing truck too are required.Since flow of power also from downstream to upstream any recurrence of negative feedback will get diminished by the use of cable side earthing truck.

Answer / arumugam

Bus earth is also called plate earth. It is using when the
motor KW is higher for example above 20 KW. Incase of any
short circuit in the motor the earth will takes place the
short circuit to earth for protect

Cable earth is using when the Motor KW is below the 20KW.

Answer / arumugam

Bus earth is also called plate earth. It is using when the
motor KW is higher for example above 20 KW. Incase of any
short circuit in the motor the earth will takes place the
short circuit to earth for protect

Cable earth is using when the Motor KW is below the 20KW.

how does circuit breaker works

1 Answers  

Explain RYB?

21 Answers  

what is mean by xlpe cables?

3 Answers  

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator gets disconnected from transformer when it is running @ full load?

3 Answers   Areva,

Where there is voltage,there must be current.Is this right or wrong??

10 Answers  

what is full wave bridge?

4 Answers  

One 15kw motor Why we used star delta feeder?why not used DOL please explain in details

3 Answers   BMM Ispat, GSK, Pitti Laminations,

What are the procedures followed for underground cable laying.....???

2 Answers   KSEB,

electricity requires a medium to flow and it cannot flow through air. so how does lightning come to earth through air without any medium?

3 Answers  

What is the formula to find out the kvar required to improve the powerfactor from .85 to .99 at 1500kw, 415v.

4 Answers   Trident,

In a incandescent bulb, if the glass is punctured, and then power is supplied, the tungsten filament blows up with a flash.Why?

2 Answers  

for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?

0 Answers