What is the formula for calculating no-load current?

0 Answers  

---

There is 3phase power cable from 1 point to the other point which is 100m away. Two point equipped with power meter and recorded 1st point is 205kW while the 2nd is 202kW and each phase average carry 400amps. To calculate the resistance of the 3phase power cable, is the formula using will be P=I2R?

3 Answers  

---

State ohm’s law?

0 Answers  

---

how to calculation increase power factor for single phase

0 Answers  

---

what is the diffference between 3 point and 4 point starter ?

3 Answers  

---

defination of static variable compensator

1 Answers  

---

Explain briefly about current , voltage and power

6 Answers   L&T,

---

If the load of transformer is getting more than its rating,,,than how to overcome this problem? Suppose thee rating of transformer is 315kva and the load is going beyond than the rating say around load: 352kva... Than how can we solve this problem without deducting the load.

14 Answers   Hyundai,

---

1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating

0 Answers  

---

I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?

0 Answers  

---

Is C.T will sense the current in both direction. As i know the C.T will sense the current in only one direction.

2 Answers  

---

what does mean for "mah" for mobile batteries like 1500mah,1300mah??

2 Answers  

---