what is looping circuit in electrical lighting circuits?
Answers were Sorted based on User's Feedback
Answer / arun
The main lighting distribution box to switch box wiring
connection is called main lighting circuit and then switch
box to one more switch box wire coonnected is called
looping circuit.
| Is This Answer Correct ? | 8 Yes | 0 No |
Answer / vipul bhavsar
LOOPING CIRCUIT is that in which the loop are given between
two light fitting a single cable connected to multiple
fitting that's y it called loop.
| Is This Answer Correct ? | 3 Yes | 0 No |
i donno whether this is the exact answer....plz check it ppl
Loop type lighting circuit
In this type, a twin and earth cable runs from the consumer
unit to each of the ceiling roses one after the other.
From each rose, another cable is run to the switch which
operates that light.
source : http://www.diyfixit.co.uk/electrics/lighting-
circuits.html
| Is This Answer Correct ? | 3 Yes | 1 No |
Answer / kumar
thank u mis...could u tell me whats the meaning of twin
cable in electrical lighting circuits......
also i got another question... that is what is booster? and
how it is connected in a circuit?
| Is This Answer Correct ? | 1 Yes | 4 No |
earth also having a gravitational force (magnetic field of north and south)but it attracts any object compare to this theartifical magnetic cant perform same as earth why?
a wire in which bulb is connected there is two terminal when one terminal is connected to phase than why the value of current shock in nutral terminal is max. or large??
i have three phase 25kva transformer but there is two phase line how can i connect to the two phase line?
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
what type of relays used in transformers?
In zero voltage we can pass supply to our body means we cant get shock its true ? how we can do it ?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
in case of OC+EF relay, how the burden is divided/calculated/shared by the CTs in case of normal (healthy condition) and during fault conditions.? three coils of OC & ef coil is conected in residual connection across the three CTS.
which starter is used for synchronous motor
Write a note on RC operational amplifier as integrator
what will hapen if secodery circuit is open of current transformer WHy neutral to ground trips when neutral touches the ground
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)