If DC supply is given to a transformer it may a) Work b)Not Work c)Give lower

If DC supply is given to a transformer it may
a) Work
b)Not Work
c)Give lower voltage than the rated voltage on secondary
side.
d)burn the winding

Question Posted / biman mandal

12 Answers
16862 Views
wbsedcl, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

If DC supply is given to a transformer it may a) Work b)Not Work c)Give lower voltage than the ra..

Answer / prasenjit biswas

d)Burn the winding.

Is This Answer Correct ?

0 Yes

0 No

If DC supply is given to a transformer it may a) Work b)Not Work c)Give lower voltage than the ra..

Answer / sumanta kumar nahak

Not Work

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

what is the pressure of vacuum circuit breaker

2 Answers

Why Auto Transformer is called "Auto"? What is the logic?

1 Answers

How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend

0 Answers

How to measure corona loss in a transmission line?(Plz ans only if u know the exact answer)

3 Answers

What is d diff. btw MCB & MCCB???

1 Answers Emerson,

Why squirrel case induction motor bar is skew permanently?

1 Answers Nesco,

A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03

0 Answers

difference between the earthing,grounding and neutral

1 Answers DLF, L&T,

what is the function of short circuit maintenance ct and droop ct.

1 Answers L&T,

how to get 48 V DC I have ... 1. 12 volt power supply board 2. DC power supply ( max. 30 v) 3. 9 volt batteries ( 2 - not chargeble)

2 Answers

WHAT IS THE THUMB RULE FOR DECIDING THE CURRENT RATING OF COPPER WIRES SAY 2.5/4/6/10 MM SQUARE SIZES??

14 Answers Dubai Group, Saudi Delta Groups, Savitha Electricals,

how to check a transformer insulation?

3 Answers Kirloskar, Kirloskar Chillers,

For more Electrical Engineering Interview Questions Click Here