what is the potential difference between line and earth?
Answers were Sorted based on User's Feedback
Answer / prashant singh
tha potential of earth is 0 volt. When we measure the
potential between them then the maximum line voltage is the
maximum potential between them.
Is This Answer Correct ? | 20 Yes | 0 No |
Answer / sree
I think the voltage between line & earth voltage should be
line voltage. i.e. in 230V system, voltage between line &
nuetral or line & earth should be 230 Volts.Then only test
lamp glows between line &earth or line & neutral.
Is This Answer Correct ? | 6 Yes | 0 No |
Answer / suraj_ojha
congratulation Mr. Prashant & madhan your answer is right.
I was wrong here.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / chandimitra
It is line voltage only.If you connect line( Live wire) and
the earth with a suitable wire the fuge will melt.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / madhan
At balanced condition, the voltage between them is Zero.
If there is any unbalance,then only some amount of voltage
exist between them.(since current flows thro' neutral at
unbalance)
Is This Answer Correct ? | 2 Yes | 6 No |
define excitaton voltage and excitation current?
What is the criteria in selecting Air circuit breaker(ACB) & Moulded case circuit breaker(MCCB) for a particular range?
Why Phase to Neutral get spark
What is the meaning of ST and HT in electrical transmission and what are thier range.
primary of transformer connected to Dc supply in series with switch, and secondary connected on ammeter, what happens when swith On and OFF. (or) if continuously On and OFF
difrent between vcb acb sf6 and mccb breakers
In our factory there is one no. of Series trip HT 6KV OCB. 1. Is it possible to measure CT out put current by 440V Clamp meter? The measurement is required for knowing the exact value of current in CT secondary to set up protection for transformers. 2. plase forward the single line diagram of AMF panel?
Why different types of connection in transformers are used? (star/star,star/delta,delta/star,delta/delta)Why we are only taking in consideration of star/delta type transformers? if only star/delta is good in practice where doses other type of transformers are used? Note: i want to know place of using different types of transformers other than Star/delta type with brief description.
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
How are load losses and no-load losses measured at site in a DG set?
define the active power?
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?