Answer / guru

Role of energy meters at Distirbution transformer is to
calculate the total output power and check with the sum of
the energy readings recorded at indvidual energy meters of
that particular distribution transformer.

This is used for calculating both technical losses and non
technical losses and technical losses from Distribution
transformer ~ consumer should not exceed 4 - 5 % of the
total output power of the Distribution transformer. For
calculating Technical losses line length , type of
conductor, no. of joints etc. in the line are taken into
account

Why consumers are charged based on Kwh basis why not on Kvah basis.

4 Answers   Unitech,

---

ohm's law is applicable to DC/AC/Both??

6 Answers   KPIT,

---

do we people experience any shock if we catch any one of the three phases (R Y B)in air with out touching ground.

7 Answers  

---

What is the effect of impedance on the heat losses in case of AC system??? Does heat losses really depends on the impedance or depends only on resistive component only..??

4 Answers  

---

Define de-sensitivity?

0 Answers  

---

---

WHAT IS THE DIFFERENCE B/W BUSHINGS AND INSULATORS? WHAT IS THE CREEPAGE DISTANCE ?

3 Answers   TCS,

---

salam,hi, i need to know what the spesification of 300amp msb...

0 Answers  

---

can any one tell in easy method for circulating current ??

0 Answers   Quest,

---

What will hapen if we run generator below 47.6hz frequency?

9 Answers   TATA,

---

If ct ratio is 250/1 and mtr is of 5 amp, what will be mf?

1 Answers  

---

what is difference between the buscoupler and bus raiser?

1 Answers   Synechron,

---

what is the use of providing earthing for tanks? i know for lightning we use earthing ? Here one of my ONGC project there is no need of lightning protection and there is no power connection near by tank in that situation also ONGC asking earthing for tanks but we didn't understanding why they asking earthing? is anybody tell exact answer?

4 Answers  

---