Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


how induction generator works?

Answers were Sorted based on User's Feedback



how induction generator works?..

Answer / jain c

Induction generator is nothing but the induction motor.
When the speed of induction motor raises above the
synchronous speed the motor will act as induction generator.
EX: Wind mill .

Synchronous speed= 120f/p

f=> frequency
p=> no. of poles.

Is This Answer Correct ?    1 Yes 0 No

how induction generator works?..

Answer / mrudang

AC generator

in between stator , rotor rotates and cut the magentic
field by 0 ,120,240 degree it produces dC
current ,commutator is convert the dc into ac ,and we get
ac

generator is for generate ac current

Is This Answer Correct ?    1 Yes 4 No

how induction generator works?..

Answer / ramesh pachamal

An induction generator is nothing but induction motor. if
the motor run more than the sysnchronous speed ie means the
slip goes on positive side it will feed the supply to same
feeder. but the excitation should be same to maintain.

Is This Answer Correct ?    4 Yes 8 No

Post New Answer

More Electrical Engineering Interview Questions

what is high and low cut off voltage of BB and DG at SPS????????

0 Answers  


IDMT relay are mostly used for protection against..??? 1)Earth Fault 2)Inter turn fault 3)Overloading 4)None of the above

1 Answers   Indian Railways,


how squirrel cage & slip ring motor works? how they differ from each other

1 Answers  


I try to check the three phase voltage in multimeter, in 125A isolator switch incommer. first i touch R phase, and then i touch Y phase using multimeter, the moment i touched, it blasts and that moment i got blindness. multimeter selector position is correct(750V AC MODE AND RED PROBE WASS IN v AND BLACK PROBE WASS IN COM. MODE. COULD ANYBODY GIVE ANSWER FOR THIS TO AVOID FURTHER ACCIDENTS PLEASE?

2 Answers  


Why is the air gap between the pole pieces and the armature kept very small?

0 Answers  


in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com

0 Answers  


why we are grounding the neutral?

1 Answers   GE,


im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar

0 Answers  


How to design the earth grid for lightning protection in an industry

2 Answers  


what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem

0 Answers  


why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?

0 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,


Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)