Answer / vijayakrishna

current: the flow of free electrons is called current.
current is flows when closed circuit is formed

voltageis defined as ths force required to move charged
particles(free electrons)from one point to another point.

power:the rate of change of energy is called power>

Answer / rajesh

talking practically current can be analogally feeled in
other way:
we take a tank which consists of water of some height.
we shall make some hole at the bottom.the bigger the hole
the smaller the resistance.
The definitions are here:
1)the disharge is known as current electrons/sec
2)the force applied on the bottom water is known as the
voltage
3)if you keep some hand at the hole you feel some force
which is power

Answer / thul_dhul@yahoo.com

electron moving current,
potential means voltage,
p=vi

Answer / majeed shoab

current is the flow of electrons during closing the circuit.
Voltage is the worke applied on wire to make the electrons
flow through it.
power is the force produced from multiplication of the
current by voltage.

Answer / anbarasu

power means high amplitudes of current and voltage

Answer / thul_dhul@yahoo.com

electron moving current,
potential means voltage,
p=vi

how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar

0 Answers  

in transmission line, if the load is suddenly increased at the receiving end of the system the phase shift will (a)decrease (b)becomems zero (c)increase (d)not be affected

4 Answers   Getco,

how many by pass system in online UPS.

4 Answers  

what is meant by HT&LT?

5 Answers  

why there is a temperature rise at different metal to metal contact at cable lug??suppose cable is aluminium and the lug is copper,than why the temperature rise takes place??

2 Answers   JK Cement,

What is the de rating factor of cable? What is the importance of the de rating factor in cable select

0 Answers  

what is through fault?

0 Answers   KSEB,

should Dy11 and Dy1 group can be operated in parallel??????

1 Answers  

What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.

0 Answers   TATA,

what is differance between kvarh $ kvah

1 Answers  

Where we can use 3.5c cables instead of 4c cables.Why?

4 Answers  

Whats changes in Transformer Oil BDV in changes in temp or Climate?

2 Answers   TATA,