Can we manually synchronize two DG sets of same ratings manually without using

Can we manually synchronize two DG sets of same ratings
manually without using speed biasing ? If yes then how?

Question Posted / satender

4 Answers
9014 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Can we manually synchronize two DG sets of same ratings manually without using speed biasing ? If ..

Answer / mohammad farman khan-abu dhabi

No, required to be speed biasing

Is This Answer Correct ?

6 Yes

1 No

Can we manually synchronize two DG sets of same ratings manually without using speed biasing ? If ..

Answer / deepak thakur

NO, bcoz its very dengerous
For synchronizing two or more DG Set we must requierd
1..DG speed
2..DG voltage
3..DG phase sequence

Is This Answer Correct ?

0 Yes

0 No

Can we manually synchronize two DG sets of same ratings manually without using speed biasing ? If ..

Answer / periyasamy

yes we can

Is This Answer Correct ?

2 Yes

5 No

Can we manually synchronize two DG sets of same ratings manually without using speed biasing ? If ..

Answer / k.prakashchandra

You can use dark or bright lamp method synchronizing .But,
speed control is required.

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

In our factory there is one no. of Series trip HT 6KV OCB. 1. Is it possible to measure CT out put current by 440V Clamp meter? The measurement is required for knowing the exact value of current in CT secondary to set up protection for transformers. 2. plase forward the single line diagram of AMF panel?

1 Answers HAL,

Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?

0 Answers

by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.

0 Answers HP,

750kva 11/415kv transformer having percentage impedence is5.64%. 11KV HV whose current 39.37A and 415V LV whose current 1043.43A.resistance is 2.5ohm. find no load loss and full load loss?

2 Answers

why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.

0 Answers Siemens,

How i can select current transformer and meters for the upgrading the panal..for 200kw to 600kw....i need to select monitoring and protection ct,s and apmpire meter ,kw meter too.

1 Answers

Distinguish between neutral earthing and equipment earthing?

7 Answers

What are the specific gravity of fully charged and fully discharged lead-acid battery?

1 Answers Mukand,

Why not instal the NGR in 11kv/433kv trasformer?

3 Answers

what is recovery voltage & transient voltage ?

1 Answers Bhel,

i need to calculate high voltage line power factor daily basics but there is meter reading kwh and kvah while calculating power factor kwh/kvah formula was right. for examble there is point c=13kwh c=1.8 lag c=1.2 lead and c=14.5kvah like that i know that p.f =kwh/kvah but c=1.8lag kvarh and c=1.2lead kvarh points i dont know if u know please reply

1 Answers

Are you connected Transformer neutral eathing with it's body earthing or earthing met of switch yard.? Yes or No ? why ?

2 Answers

For more Electrical Engineering Interview Questions Click Here