Answer / bhai

just take one phase and one nutral and make a 1 phase
connection...

Answer / dinesh kumar

using a rectifier, conovert the 3 phase into DC and then
invert it to get a single phase
Is this correct?

Answer / sachin lakhe

Simple logic take one phase and neautral to make single
phase,we can use rectifier to conovert the 3 phase into DC
and then
invert it to AC a single phase
but it's long and costing method.

Answer / pillay

I believe all three answers are correct but I can add one more.
If you don't want to use transformers than connect an appropriate
3 phase motor to a single phase alternator and run the motor the
out put from the generator would be single phase.

Answer / narend

take any one phase from the three phases and
for neutral connect all three phases

Answer / kaniyamuthan

OK I ACCEPT THAT WE CAN TAKE SINGLE PHASE WHILE CONNECTING ANY ONE OF PHASE AND NEUTRAL.BUT IF IT IS A DELTA SUPPLY MEANS? AND ALSO ONE PROBLEM IF WE ARE TAKING THE SUPPLY FROM ONE PHASE IT WILL GET OVERLOADED (UNBALANCED).

Answer / gajawadasrikar

my doubt is that is that is possible of converting three phase current to single phase ?

Answer / rohit gehani

give an earthing 2 3 phase current 2 make single phase ..
in trains dis types of methods r used ......

what is laser diodes?

0 Answers  

What is phase angle? and what is importance to measure it?

2 Answers  

what will happen if transformer given dc input

5 Answers  

where any change in supply line due to the incipient faults in three phase induction motor

2 Answers   ABB,

Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.

0 Answers  

Draw a Block diagram of TWO UPS systems connected in Parallel in Paralled mode?

0 Answers   HSL,

How to calculate HT XLPE CABLE for 11 kv / 433 v , 1500 kva oil type transformer system? plz provide step by step calculation

15 Answers   Engineers India, Indian Railways, Polycab, Shashwat, Sitara Energy, Sonali Bank,

What is a copper loss or i2r loss pc?

0 Answers  

Leading power factor means what? what is the power factor value while in power factor is leading? is power factor greater than one? In some cases i heard pf 0.8 leading then what about 0.8 lagging?

1 Answers   Rockfort Engineering,

I am a possesor of c licence from 1993. I forgot to renew during the year 1998. During that time I was working at TNEB to till date. Is there any possibility to get renewed? or to apply for a new one?

0 Answers  

derive the formula of amp hours is calculated for 12v battery.where no. of plates is given

1 Answers  

Why hydropower stations are preferred solution for meeting peak loads in grids?

0 Answers