Answer / sewagudde

the automatic voltage regulator (AVR) senses changes in
voltage and sends a signal to the controller on the tap
changer to either raise or lower the tap.it should be noted
that the tap changer is always located on the HV side of
the transformer inorder to interrupt smaller currents as
compared to the LV side

Answer / debasis

There is controler which sence the voltage & give command
to a stepper motor that how many step(s) & what direction
have to go for achiving the required voltage.
And the changeover held inside a oil chamber to avoid
sparking.

how capacitor pass ac voltage practically?with increase frequency and cpacitance?

1 Answers   DELL,

---

What is 11 N1 and 12 N2 in single phase Transformer ?

0 Answers  

---

How to select Main CB Rating for 220 KW Load?

3 Answers   Voltech,

---

What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection

0 Answers  

---

dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?

0 Answers  

---

Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???

0 Answers  

---

How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?

0 Answers  

---

Why PT burnts?

2 Answers  

---

What are the questions asked in PRDC pool campus test?(bangalore)

1 Answers   PRDC,

---

What is the simplest formula to calculate the rotor diameter of a synchronous generator?

0 Answers   PEI,

---

During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative

0 Answers   Core Solutions,

---

PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com

0 Answers   RRB,

---