Interested to Buy Any Domain ? << Click Here >> for more details...
how we can convert 3 phase to single phase without using any transformer
- 8 Answers
- 12808 Views
- I also Faced
- E-Mail Answers
Answer Posted / gajawadasrikar
my doubt is that is that is possible of converting three phase current to single phase ?
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
What is the differentional relay...what is the work of this in power Tx. how it is works..
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
What are the three major categories of error?
Explain the process of commutation in a dc machine.
difference between main metering kiosk and check metering kiosk
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Testing report of Earthing of 3.15 MVa PTR.
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
for a 400kv t/m line with 10 ampere current will corona occur?
Why a tesa lamp is glow between two phase?
Batteries. What is the difference between Lead and Nickel batteries ?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
Explain what is electric traction?
