why the desirable efficiency for a motor is 60%, but in case of transformer, it is above 90%?
1 4083how to calculate Amp, 2 different Amp of batteries? Example: No. of Batteries = 2 Battery voltage = 12V 1st Battery rating = 17AH 2nd battery rating = 30AH between parallel connection then output volt 12v Amp?
2 5360For 6600/433 distribution transformer we apply secondary side 433 volts how much voltage in primary side.
2 5121whenewher three phase supply is given to induction motors revolving/rotating field is created & rotor rotates.When the three phase supply is given to three phase transformer then revolving,/rotating field is created or not? if not why?
1 3440how could we findout the lightning arrester failed or not in live circuit? Is there any instrument to measure the high voltage at the time of sky lighting?
1 4039Post New Electrical Engineering Questions
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
What will be result if we connect LT votage to the terminal of HT motor?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
How to design the NGR Resistance
Which is the oldest hydropower plant in india?
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
percetans
what is cascade speed control device?and how this device control the speed of motors?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
what is effect of 5amp fuse on 2mva pry protection of transformer
What are the properties of a resistor?
what are the 4 rules to start the motor?
State the formula for overall efficiency of thermal power station
does buccholz in a transformer use batteries
Which do you think is the most significant cause of energy loss in a factory?