Answer / gunasekhar

the resistance offered by earth to absorb the high voltages and body shocks of electrical equipment. it ranges from 0.5-5 ohms.

Answer / guest

Ra+Rb+Rc=R
Ra=Length/ depth of the ground electrode•Electrode material
- Solid Copper, Stainless steel (High conductivity,
highcorrosion resistance but low strength & high cost)-
Copper clad steel (high strength, high corrosion
resistanceand low cost)
• The diameter of the rod
- Has little effect- Resistance would only decrease by 10%
by double thediameter
(
R
B
) - The contact resistance of the surrounding earthto the
electrode is negligible.(
R
C
)- The resistance of the surrounding body of eartharound the
ground electrode
- depends on soil conditions such as soil resistivity
4

Answer / vinoth

the earth resistance should be less than one

Answer / mohan.s

earth resistance is 2 ohm

Please send 110 kv sb station full single line drawing(sld)

0 Answers  

---

What is the ladder circuit?

1 Answers   Mitharg Information Systems,

---

line vltage of three phase distribution transformer is 433v and phase voltage is 250v,but we required 230v for domestic distribution,then how we reduce phase voltage of transformer

5 Answers  

---

why ct output is in 5A?

3 Answers  

---

What are the advantages of star-delta starter with induction motor?

7 Answers   Merchant Navy, Naval Academy, Samundra Institute of Maritime Studies, YMCA,

---

---

What does negative slip of an induction motor signify?

10 Answers   Tata Elxsi,

---

if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current

0 Answers  

---

Why induction motors draws higher current during starting condition?

1 Answers  

---

what is power factor in ac ckt ?

5 Answers  

---

please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula

0 Answers   Foxconn,

---

What type of pipe material G.I or M.S is used for sprinkler system?

2 Answers  

---

What is the function of attenuator in cro?

0 Answers  

---