For 6600/433 distribution transformer we apply secondary side 433 volts how muc

For 6600/433 distribution transformer we apply secondary
side 433 volts how much voltage in primary side.

Question Posted / rajeshnunna.023

2 Answers
5096 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

For 6600/433 distribution transformer we apply secondary side 433 volts how much voltage in primary..

Answer / nidal

TIS WILL QUIDE ME TO ANOTHER Q.
Can WE use a step down transformer as step up transformer
by reversing the primary voltage as a secondary voltage?

THE ANSWER IS YES WE CAN. BUT CARE SHOULD BE TAKEN FOR THE
NEW SECONDARY ( OLD PRIMARY ) AMPER NOT TO EXCEED THE
NORMAL RATING CURRENT.

Is This Answer Correct ?

3 Yes

0 No

For 6600/433 distribution transformer we apply secondary side 433 volts how much voltage in primary..

Answer / gvsubbarao

If is really 6600/433 transformer,definetly it will show 6600

Is This Answer Correct ?

2 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

why are u join ntpc

0 Answers NTPC,

can HT cable or HT bare conductor used for LT line? is yes what would be the current rating?

2 Answers ACC, wbsedcl,

What is the full form of PSD & CSD ?

6 Answers NIFT, PNG Power, PSD,

how to calculate the earth fault current

0 Answers

What is vacuum circuit breaker.define with cause and where be use it device?

0 Answers

dielectric strength of vacuum is greater than SF6 but for 132Kv uses sf6 breaker & for 33kV uses vaccum breaker why such a contradiction?

2 Answers MSETCL Maharashtra State Electricity Transmission Co Ltd,

why the transformer secondary voltage is more than the load end voltage like t/f 11KV/433V for 415V(terminal voltage)

4 Answers

what ll happen if neutral is not shorted with phases while doing transformer short circuit test & what ll happen if neutral is connected to ground?

1 Answers

1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?

0 Answers

1.In two wattmeter method if one wattmeter shows Negative reading then wat is reason? 2.Wat is the reason for low voltage in houses? 3.Wat is meant by current and voltage? wat is difference between the two?

10 Answers Engineering,

What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA

0 Answers

what is the purpose of NGR?

25 Answers Assam Electricals,

For more Electrical Engineering Interview Questions Click Here