In the market there is availability of MCCB & ACB (800A), So, Where i can use MCCB & ACB for the same Rating?
1 1848How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
1255why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
1237Post New Electrical Engineering Questions
one electromagnet is called
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
physical identification of HT & LT panel
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
How to decide cable tray size?
why electron produce magnetic field when it is in motion?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
Motor,transformers,capacitor tubelight etc....
what is is the potential diffrence between two phase ?
How to calculate wire length,size & current? ( related to control panel)
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
How to check the cable fault / hv test of transformer cable.