Company Name Starts with ...
#  A  B  C  D  E   F  G  H  I  J   K  L  M  N  O   P  Q  R  S  T   U  V  W  X  Y  Z

  • SPCL interview questions (3)
  • SPCL technical test questions (3)



SPCL Interview Questions
Questions Answers Views Company eMail

I have 12MW gas engine based power plant its running parallel with grid. my problem is When cpp run in island mode(without geb) that time geb transformer power factor is 0.2 lagging. When cpp run with parallel that time power factor is 0.94 lagging So how can i maintain power factor ofgeb transformer in island mode 0.9 lagging?

1 753

tell me quantitys of matal, sand and cement in 1:4:8 and 1:2:4

9 90800

Is there any codal provision for the use of Micro Silica in concrete?

859

How to calculate sand,cement for 1:5ratio brick masonary

4 5927

What is the correct position of lapping splice of reinforcement steel bars in a beam at top & bottom of the beam?? what is the reason for this location?..what are the factors affecting lapping location in beam?

6 7336

two phases with neutral supply can be taken in 3C X 10 sq.mm cable .

97

Post New SPCL Interview Questions




Un-Answered Questions

Please help me in this entries Pass accounting entries for the following transaction in the books of XYZ company. A rendered professional service to company XYZ and sent an invoice dated 01/01/2016 for Rs 1,00,000/- + service tax Q1. Pass journal entry for the invoice received considering the service tax and TDS. Q2. Payment was made on 01/02/2016 by cheque. Pass payment entry.

351


How to tell about our academic project in interview?

836


what are the general webtesting questions and how to respond them in generally in interview point of them

809


What is Summarising

786


what is the difference between electrical and electronic chokes

527


how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?

1413


What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.

652


All shot cut key use in the tally software & it's uses

713


How to calculate CFM in Compressure or Blower? EX. I hv Blower with 5hp motor.then how to calculate the CFM?

848


if 2 is passed as an argument to the method,void GC.Collect then what would be the result?

312


What procedure do you use to sterilize dental equipment?

290


is ther a requirement for lintel to be casted in 200mm thick siporex block? kindly mention the advantage and disadvantages?

1035


How can you filter out specific type of file using file system controls?

614


I'm busy writing a report that's using report bursting, to be able to do this I need to use a sequential section. Using a sequential section cause the grouping of the original report not to work. Please can someone give me advise on how to come past this problem, the report need to use grouping as it depend largely on totals ect, and I need to use a sequential section within the report to be able to use the report bursting facility.

1373


how to Create population with sufficient genetic diversity ?

962




SPCL Interview Questions
  • Civil Engineering (4)
  • Electrical Engineering (2)