50 electric bulbs are connected across supply of 220 volts. After one bulb is fused remaining 49 bulbs are again connected to same supply. which case will have more illumination & WHY????????
KJ,
5 7270We have Diesel generator of 200KW but load connected to it only 100KW. Pl. brief me about fuel consumption.
ARDE,
4 6291what happens when ac supply is given to the dc motor and dc supply is given to the ac motor?
GATE,
1 3813what is the soil bearing capacity for a 5 floor multistorey residential building and which type of soil ? what is plinth beam? in wall load calculation center to center column distance is considered or not/
1929minimum number of bars in a beam? minimum and maximum column size and beam size ? minimum and maximum aggregate size used in multistorey residential building for columns,beams,slabs?
4972What is the name of process In VFD frequency are increase then voltage increase & frequency decrease then voltage decrease?
1571mt gre score is 272 and ielts score is 5.5, will i get admission in any of the universities in usa..will i get visa for this score??
1 6394
if size is 235cmsx15cmx100cms so how many cement bags and how many sand bags are used for concrete mix
you are on site,the plant trips,you are approached by operations,what do you do?
why burdens of VTs is more than CTs?
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
What industries require filtered compressed air?
Plz tell me the GATE interview question asked for ECE branch?
Tell me what is chroma?
sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...
What are monitoring methods for electronics activities?
How fuel oil consumed by medium engine?
Explain what is the difference between inductance and resistance?
A bar of steel 24 mm in diameter was subjected to a tensile load of 60 kNs and measured extension on a 20-cm gauge length was 0.009 cm and the change in diameter was 0.00375 cm. Calculate the Bulk modulus?
which VFD is better ( LT or HT)
What is coefficient of contraction?
what is the acceptable limit value for Desolve Gas Analysis/