Answer / sudhakar g

If we Dc supply to primary side of the transformer means
the Flux doesn't change and it causes the winding of the
Transformer will burn....

Answer / jadhav babu

if we give dc supply to the transformer the primary side
winding will get induced emf which is constant ,but we
require an variable emf so that mutual induction takes place
and emf is induced in secondary of the transformer .if dc is
given for a longer period the transformer may get damaged

Answer / benu

with dc supply reactance part of total impedance will be zero.
,,net impedance will be less,primary current will be high which will generate excess heat in winding,resulting in burning of pri winding

Why DG set is not installed in Terrace ??

0 Answers  

---

in thermal overload relay class 10A indicate what

6 Answers   Reliance,

---

Why we use d.c. meger in a.c. induction motor?

1 Answers  

---

how we calculate the dick for a pole?

0 Answers   Power Grid,

---

what is meant by bus bar and outgoing/incoming breaker in an electrical/electronic circuit

3 Answers  

---

A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????

8 Answers  

---

How much current can a 3-1/2 core 100 mm wire carry?

3 Answers   Epitome, Focus, Focus Energy,

---

Consider a case that two 200 hp motors are connected to 500KVA transformer. For improving power factor can we add capacitors in common bus bars to motors. Or should we add capacitors for each individual motor?

2 Answers  

---

What are the factors to be considered during the Synchronization?

3 Answers  

---

what are the problems are there if power factor is leading

3 Answers   NTPC,

---

Why inductor short on dc and capacitor allow to flow ac?

1 Answers  

---

As a good company employee, can you report your supervisor to the company management if he or she is going against the company interest in his or her actions?

1 Answers   MAHINDRA,

---