Hi,I got a call from vssc,kerala for the technical assistant in automobile,would u suggest me how to prepare for this,quickly
5722A copper wire of length l and diameter d has potential difference V applied at its two ends. The drift velocity is vd. If the diameter of wire is made d/3, then drift velocity becomes
1 6166what is the difference between plant earth and instrument earth? and what type of cable( cable size ) used for both? and why ?
3048We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
ARDE,
1832
Describe the stress and strain curve of steel.
If we want to change a contactor of faulty one what are the conditions want to fullfil
Explain why a voltmeter should be of very high resistance?
Which furnace burns low-ash fusion coal and retains most of the coal ash in the slag?
What are the disadvantages of autotransformer?
one fuse has following data 80A 415V -6.9W HN SIZE 00 100 KA gG Please tell me about what is the mean of 100kA gG
20 mpa what is the quantity of cement sand and aggregate in one cubic meter of pcc non rainforcement concreate kindly answer including formaula thanks
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
What is the best way to control an oversized, horizontally oriented shell and tube steam heater?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
Derive intrinsic stand off ratio.
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
What is mean by STUB protection?
I am helping a friend to design a concert hall. No need for super architectural show off. Just a rectangular box. Knowing that in my country constructions are done with reinforced concrete and concrete blocks and that the hall's dimensions are, length: 75 meters, width: 32m height: 9m, and that there should not be any columns inside, what would be the size of the columns, beams and roof slab ?
What are the types of load?