in three phase with neutral connection, what will happen,if
the neutral is in open condition with single phase
distribution panel ?
Answers were Sorted based on User's Feedback
Answer / sumit rathi (mzn)
neutral point shuld be earth for unbalance load mainly.if
its open neutral voltage will be changed according to
load.when load will be unbalanced nuetral voltage will be
increased .its can be harmful for equipment.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / roy
this is a dangerous situation. neutral wire will act as a
phase wire in the equipment.
| Is This Answer Correct ? | 0 Yes | 0 No |
whu does the power factor of diesel generator always be 0.8. please explain
what will happen if the secondary of current transformer kept open....
Essential condition for parallel operation of two single phase transformer is that they should have same A polarity B kVA rating C voltage ratio D % impedance
Ceiling fan motor wiring Hi, I have 2 ceiling fans broken. The receiver/control units burned out due to lightening. One Harbor Breeze and one Hunter's I took them apart (remove receiver units). Now on both of the motor I see 4 wires coming out from each motor I really want to know the function of each wire. Are there anyway I can test to see which is which? After searching forums I know these 4 wires are from 2 sets of coils inside the motor, one is Start winding and the other is Runing winding I could not find the receiver/control unit any where, so I am planing to buy Capacitors and universal remote controls to make the fans run again. Anyone has any idea how to do the wiring, please help Thnks
how to operate and maintenance of 1500 kva diesel generator set
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
SUTIABLE FOR ohm's law super conductor
While connecting bulb in Series/Parallel,there is any difference in glowing
What is maximum permissible length of cable from transformer (33kV/0.433kV) HT side to HT panel which contain VCB? In which standard i shall get this information.
In a transformer ,when voltage decreases current increases. but this is a violation of oms law.why?
I WANT HOW CALCULATE TO CABLE FOR WELDING PLANT ?
How to calculate load taken by a cable?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)