Answer / chandrasekarapandian

A check
1. replace Air filter
B check
1. Replace Oil filter, Loop filter , Fuel filter
2. Replace new oil
C check
Check for exhaust line(smoke line)

All these checks depends upon DG capacity & running
condition

what are adantages of OC and SC test over the load test?

5 Answers  

---

What is current & voltage ? Voltage perform at any load without current or not?

0 Answers  

---

can we use 220 volt 15 w a.c. lamp on 220 volt d.c.

6 Answers   TCL,

---

what is the purpose of bypass mode in energy lighting transformer?

0 Answers  

---

If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?

0 Answers  

---

which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?

0 Answers   TATA,

---

what is pilot wire? what is the use of pilot wires?

9 Answers  

---

we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers  

---

what is the difference in between short time and continuous rating?

1 Answers  

---

what is the reason for drop in freq. from 50 hz at generating side to 49.8 ,49.6 etc.at receiving side???

2 Answers  

---

What is the acessaries distribution transformer ?

11 Answers   Bhel,

---

77 In constant power region of 3-phase IM torque-speed characteristics, the torque is proportional to A speed B slip C 1/speed D 1/slip

1 Answers  

---