what would be the minimum flow rate that we can measure on rotameter..?

0 Answers   TATA,

---

why we are not using the turbine flow meter in the steam service?

0 Answers   Jaypee,

---

I want to measure flow by using DP Tx and range is 0 to 1200 Kg/cm2 ?

2 Answers  

---

How to isolate a DPT from line in the condition that process must not be disturbed,and process is also critical and no bypass is available.?

4 Answers   Descon,

---

what is INSTRUMENTATION ? specify..

7 Answers   Reddy Labs,

---

can u please tell me the different types of valve uses and wt purposes it is used ~!(controlling the flow other than that which valve should be used in what place)

2 Answers  

---

what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????

1 Answers  

---

PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear

0 Answers   MSL, SRAAC,

---

How Honeywell FSC is functioning and what is its purpose? Can we bypasa it and only use DCS instead of that.

3 Answers  

---

how can calibrate vacume trasmitter by HART COMMUNICATOR ?

3 Answers   Bajaj, IMECO,

---

How we can do the linearity test for Bently Naveda Vibration Probe?

1 Answers   Sabic,

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---