PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and

PT RTD Range: -200 to 500 degree celsius
If I configured in DCS Lower range and Upper range . In face
plate it shows red colour due to overa range how was the
characteristics look
If the temperature is more than operating range. how was the
characteristics look . whether its in Resistance vs
Temperature curve is Linear or Non linear

Question Posted / selvakumar

0 Answers
2001 Views
MSL, SRAAC, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Instrumentation Interview Questions

What is rang ability?

0 Answers

HOW TO CALIBRATE A DRUM LEVEL TRANSMITTER

2 Answers

defffrence between instruments and instrumentation

8 Answers

send me last 5 years questions asked in rrb chennai, for section engineer

0 Answers RRB,

How d.p. Transmitter can be applied to open tank?

0 Answers

how to calculate range of level transmitter?

0 Answers TCE,

I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?

0 Answers

what is the daily job of an instrument commissioning supervisor

1 Answers Petrofac,

what is a instrumentation ?

10 Answers

where cascade loop use ?

0 Answers KNPC, KOC,

can any one tell leakage class in control valve depend on which parameter and there is any specific table or chart for selection of valve leakage class

2 Answers

what is diffrence between cascade & three element system.

3 Answers

For more Instrumentation Interview Questions Click Here