I want to measure flow by using DP Tx and range is 0 to 1200 Kg/cm2 ?

Question Posted / mayur.kevadiya

2 Answers
7071 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

I want to measure flow by using DP Tx and range is 0 to 1200 Kg/cm2 ?..

Your UOM for flow is wrong, it cannot be a pressure UOM.
The 1200Kg/cm2 cannot be the DPT range either since a diff
pressure tx with a range of 1176Bar does not exist.

So unless you ask a sensible question with accurate and
detail information with it, and look at what you write
before you post the question, no one can or would want to
help you.

Is This Answer Correct ?

13 Yes

1 No

I want to measure flow by using DP Tx and range is 0 to 1200 Kg/cm2 ?..

Answer / haridass

My dear Sam, the question submitter may be new for the
instrumentation, plz dont discourage him or the people who
ask like this type of questions.

My dear friend Mayur.kevadiya, the DP range of the flow
transmitter will not be with this much ranged values, it
will be in 0~100inWC, 0-2500mmWC, 0~100mbar, 0~200kPa such
like low ranges.

And only with the DP range we can not say the line flow, to
find that we need more data, such as, line size, orifice
bore dia, line pressure, flow density, flow coefficient,
etc.

Refer the link for more details:
http://www.efunda.com/formulae/fluids/calc_orifice_flowmeter
.cfm

Is This Answer Correct ?

5 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

How works weighfeeders in cement industry? what is the working principle?

0 Answers

which are types of orifice tap ?

2 Answers

applications of plc in printing and packaging?

0 Answers

Which buffer solution is used for PH transmitter calibration?

3 Answers

What is the working principle of Bentley Nevada 3300

1 Answers SMIT,

Explain the key components of control loop?

0 Answers

diff bw range and span?

3 Answers

what is the safety integrity levels (SIL)

1 Answers

How to calibrate a orifice differential pressure flow transmitter in process?

1 Answers

i want to know for good instrument engineer or success how many software knowledage required & from which university

0 Answers

-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.

0 Answers

what is IPS (instrument protective system)?

2 Answers

For more Instrumentation Interview Questions Click Here