Interested to Buy Any Domain ? << Click Here >> for more details...
what is the potential difference between line and earth?
- 11 Answers
- 17873 Views
- I also Faced
- E-Mail Answers
Answer Posted / sree
I think the voltage between line & earth voltage should be
line voltage. i.e. in 230V system, voltage between line &
nuetral or line & earth should be 230 Volts.Then only test
lamp glows between line &earth or line & neutral.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
What does the term “voltage regulation” means?
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
how desiel generate sart fail of eb?
why do we lay up the core of a cable?
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
how to calculate fuse rating for a motor
what is the minimum winding resistance of 30hp compressor, to run or to switch on
Why use in ht motore
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is the formula for hv test for cable and circuit breaker..????
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
