why should we have to maintain pf in our site 0.9????????
Answers were Sorted based on User's Feedback
Answer / onkar tate
power=voltage*current*pf
hence,
current=power/voltage*pf
thus when pf is less current carried by conductor is
greater at constant voltage
due to this trasmission losses are increases,size & hence
cost of conductor increases
Is This Answer Correct ? | 27 Yes | 0 No |
Answer / pillay
Power providing companies impose a penalty if the PF drops
below a particular level because it would be very expensive
for them to provide power at a low level of PF.So it is the
responsibility of the consumer to maintain the PF above that
level.
Is This Answer Correct ? | 12 Yes | 6 No |
Answer / venkatesh
Because the power will maintain constant and storing
capacity
Is This Answer Correct ? | 2 Yes | 10 No |
What's the differs between voltage & current & emf.
Why is the diffrential protection in DG. What if the CT polarity is reversed while connecting for the same type of protection? How polarity can be made ok?
What is ac and dc drive.
How much area a lightning arrestor can cover?
can i use 10 mfd + 6 mfd instead of 15 mfd capacitor in single phase motor as running capacitor
what is meant by GOD in transmission system ?
What is signal flow graph?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Uses of induction motor
How to Design green buildings services? What is the advantage to design green building?
How do you reset circuit breaker?
1 Answers Bhel, Kaveri Steels,
why do some transmission towers have two insulators at one side and three insulators at the other side