i am also applied for the AAI jr executive (CIVIL) written
test. pls forward me the syllabus & test pattern if any
question papers, any one got reply for this quaries? if ANY
ONE KNOW THE DATES OF WRITTEN EXAM PLZ TOLD ME.
dreamyagrawal@yahoo.com
Answers were Sorted based on User's Feedback
Answer / rakshit
HELLO FRIENDZ I AM RAKSHIT SPEAKING PLEASE HELP ME PUT IF ANY ONE HAS PREVIOUS YESR PAPER THEN MAIL ME TO rakshitkaushik@ymail.com. i think many friends had given the test too as read by me on the same page. so please those frnds are reading this plz help me by mailing the paper at the mail id:-rakshitkaushik@ymail.com
Is This Answer Correct ? | 1 Yes | 4 No |
Answer / rakesh
i am also applied for the AAI jr executive (CIVIL) written
test. pls forward me the syllabus & test pattern if any
question papers, any one got reply for this quaries? if ANY
ONE KNOW THE DATES OF WRITTEN EXAM PLZ TOLD ME.
rakesh_kund@yahoo.com
Is This Answer Correct ? | 1 Yes | 8 No |
What are the materials used in building a gravity dam?
What is CRMB ? And how it is beneficial to the service life of the road?
WHAT IS MIS REPORT?
What is the nature of duties & responsibilites senior civil engineer ?what is self confident & satisfaction should be a senior civil engineer?
Which IS Codes used for the steel reinforcement work?
In IS:456-2000 the workability of concrete is given in mm (slump)in cl.7.1. In IS:10262-1982, cl.3.3.4 & table-6 says +/- 3 percent adjustment is required in the quantity of water (calculated as per table-4 or 5), for each increase or decrease in the value of compacting factor (i.e. workability of concrete) by 0.1. How it is possible to calculate the exact quantity of water required for a particular grade of concrete? What is the relation between Slump & Compacting factor of concrete?
indian standard split spoon sampler
mix design ratio of M30 concrete
how to calculate the steel for 450 sft slab, please tell me the solution method
on what basis the partial factor of safety are decided? form the load combinations
I want to know about rolling margin of steel :- For eg. If 2nos. bundle of 8mm dia steel with17 rods each of length 12m comes to store. During testing of 1m rod of each bundle it was found that 1rod has weight .405kg/m while other has .385kg/m. Now what will happen in case of steel payment and measurement payment ? Regards,
what is the basic fundamental of contouring?