What is Wlak Test in Fire Alarm System????
Answers were Sorted based on User's Feedback
Answer / joy
walk in test in a FDAS is a built in program done in the
Fire alarm control panel where you can test each zones
assigned. It is an automatic testing program to see if all
detectors connected or located from different areas of the
building is really working or if one detector in a zone fails.
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / ravi
It is an Automatic Testing of Smoke Detectors..
By this onle one person can test the Smoke detector & d
panel will reset every 30Sec onces automatically......
Is This Answer Correct ? | 0 Yes | 2 No |
how test transfomer(3 phase75kva) by megger
Single line diagram for dbb (double bus bar)system.
what is a types of short circuit and what is a types of distance protection tests
How many points does a Circuit can have?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
Master trip relay code no
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
Which is the best between SCADA & PLCC & Why ?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
How much CTs are required to measure th curent in DOL starting of motor?PLs explain.
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
two transformer connected in parallel.tap change are different.if i want to on the buscoupler what happen?