Answer / stanley electrician

AH = Amps x hours.
If we use 15A from a battery of 1000AH, then we use upto
66 hours. (i.e., 66x15= 990 ). Th duration of usage is
decreased according to high amps.

Answer / stanley electrician

power factor is not consider in DC side.

Answer / stanley electrician

The question is about the battery. The battery had only DC
voltage source.
In dc, no power factor.

Answer / balaji

ampere hour = ampere rating*no. of hours

Answer / saleem

If u dont know the AH of the battery and u want to check
the name plate detail i think following procedure is
correct.

Connect some load up to batter get dry.and found.
How many Amps(A) load u hav given and how much time it
carried (In Hrs).
A*H=AH of the battery

Answer / muthu

Ampers*Hours

Answer / sandeep mulik

wattage X 20% then divde by lowest volage of battery say 12v
is 10.4 or 10.5 then multiply by no of batteries i.e ( dc bus )

e.g 700 watt x 20% = 840 watts.

then lowest battery voltage is 10.5 assume dc bus is 36 v
means 3 nos battery then , 10.5 X 3 = 31.5

now , 840 / 31.5 = 26.66 amp per hour so use 26 amp battery
X 3nos for 1 kva online ups will give 1 hour backup.

if you want for 2 hrs then , 26.66 X 2 = 53.33 ah , you will
require 60 ah battery for backup of 2hrs .

Answer / vikram rana

va*power factor/vdc*k*efficiency

Answer / ramakrishnan

AH = (VA * Power factor)/(Output Efficiency * Vdc * K)

K is diversity factor
for 30 mins back up 0.9
60 0.5
120 0.3
240 0.2

Efficiency is 0.9
Pqwer factor is 0.9

Any doubt about UPS contact
98409 92005

Answer / ramakrishnan

i had given the answer for AC UPS Systems not inverter

Why we use two wattmeter during block rotor test and no load test of 3phase induction motor? And how can we understand the neat power requirement of from this test?

2 Answers  

Why do you use an isolator on both sides of the circuit breaker? ( shortly answer)

2 Answers  

Where is 2 phase supply used commercially?

3 Answers   NTPC,

whether choke act as a voltage regulator in tubelight or not?

1 Answers   Bhel,

how the alternator transfere mechanical energy to electrical one ??

3 Answers  

1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.

0 Answers  

what is pure resistive circuit and pure inductive circuit

1 Answers  

What are the advantages and disadvantages of closed-loop control system?

0 Answers  

IP55 protection stands for

1 Answers   Hofincons,

Why diesel tank kept in 990 ltrs

1 Answers   Reliance,

what is the cable size we can use for 11kv and 33kv ?

3 Answers  

why do we have another cartridge filled with oil fitted at the bottom silica gel cartridge in power transforers

1 Answers