why our indian system choose the 230 volt for single
phase&415 for 3-phase voltage,in forign side 110 volt is
used what is the difference
Answers were Sorted based on User's Feedback
Basic rule of electricity is W= V*I now wattage would be
the rating of the quipment which remain constant means the
voltage is decrease then current will increase but if
frequency is increase current will decrease now as per this
in foreign the frequency is increase & voltage is decrease
so the required insulation level is decrease. in india the
voltage level is 230 & frequency 50.
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / muhammad ashraf
In forign countries, they use 200V in three phae at 60 HZ
and according to the principal of electrical theory in star
connection phase voltages are under root 3 time less then
line voltages, and for domestic control we use star
connection, this the reason that in India and Pakistan we
use 415V three phase supply and according to the formula
single phase voltages will be 230, and according to this
standard our home appliances are design at 230 volts. And
forigner use 200V three phase supply And according to the
formula thier single phase voltages are 110V. And thier
design of home applinces are 110V.
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / elangkumanan
forign side all home appliance material volt 110v but
indian appliance volt 220volt that is a difference
another forign transformer step down volt default use
110v but inian system volt 230 volt that is different
| Is This Answer Correct ? | 4 Yes | 16 No |
How to measure corona loss in a transmission line?(Plz ans only if u know the exact answer)
If two hack saw blades, seperated by 1mm thick paper,are connected across 230volts, and immersed in water,then they start getting heat. This is fact,i dont know how they get heated.Blades are not directly connected together. Please if anybody knows the fact ,revert back to me
why we use REF and Differential Protection in one transformers?my doubt is both protections are operated in internal fault only.why we want to use 2 protections?please clarify.
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
What is a single phase autotransformer?
Which Motor used in Fan's Motor ?
3 Answers Matsui Technologies,
why an ac solenoid valve attract the plunger eventhough we interchanges the terminal?will the ploes changes?
What is maximum permissible length of cable from transformer (33kV/0.433kV) HT side to HT panel which contain VCB? In which standard i shall get this information.
when is the Ohms law is applicable?
how to find value of resistance when 1 kw consumption for 10 minutes
what's float charger and boost charger? why it's used?
2 Answers APCPDCL, PTCL, Rolls Royce, Siemens,
Explain the grounding concept adapted in aircrafts?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)