Answer / sridhar

1. to identify the source & the destination
2. to identify the classification of Zones.
3. identify the shortest / nearest route to avoid max.
length of the cable & to avoid road crossing
4. to select the cable size wrt load & route length
5. to select the cable size wrt load, calculate the
starting & running voltage drop.

why core is useful for a transformer ?and also in its operation ?

0 Answers  

---

What is core CT & it's function?

0 Answers  

---

In a Circuit how the MCB and Fuse ratings are calculated. And shall the fuse follws the MCB or it is otherwise?

16 Answers   Emerson, HCL, Thirumalai Chemicals,

---

How to design the blower for motor? how to two blowers connected in motor?

1 Answers   Ashok Leyland, TATA,

---

How does a system control centre in a utility plant gets the grid frequency of the electrical network (50 Hz or 60 Hz)by the SCADA system?

1 Answers  

---

WHY WE NEED NEUTRAL FOR 3PH 400 OR 415 VOLTS POWER SUPPLY (4 WIRE SOURCE).

5 Answers  

---

why neutral and earth should not be connected on 3 phase 440v/50c/s supply at consumer side. where as on 25kv/ac/50c/s railway traction substation neutral and earth will be connected and track at substation. and track will act as neutral and earth. Reasons for this is needed urgently

4 Answers  

---

Dear sir, please tell me how many day use CTPT transformer

1 Answers   Daya Engineering Works,

---

can u guys pls suggest a good material for learning abt switch yard and its components

2 Answers  

---

can we use 220 volt 15 w a.c. lamp on 220 volt d.c.

6 Answers   TCL,

---

How to calcute the cable size for both HT and LT please specify the formula for that Regards Chethan C

1 Answers   Bhel, Student,

---

what will happen at the time of CT saturation?and what will be the Relay's function at the time of CT saturation?

2 Answers  

---