Answer / elango.kalp

energy efficent motors means losses are minimised.
1.area of cross section of conductor have been increased to
reduce copper loss.
2.thickness of lamnination has been reduced and crgo
technique has been used.
3.c3 ballbearings have been used it has good clearance
between each rollers and lubrication is proper-friction
loss is reduced
4.rotor length is increased and air gap b/w stator and
rotor is reduced- windage loss is reduced
5.plastic fan has been used

the over all efficency of energy efficient motor is 93.6%

grr resistance & contrator malt continuous

0 Answers   Pioneer Labs,

---

Explain why machinery used on a.c supply is usually rated in KVA instead of KW?

10 Answers   EEE, Mtandt,

---

I want formula to calculate cable size as per load given in kw & amp.I searched many sites but didn't right answer.Plz reply me asap.

41 Answers   Armco, BEL, BGS, Biocon, BRB Cable, Crystalline Chemical Industries, DLF, Doshion, Electrical, Gold Roof, L&T, Lanco, MEIL, Oman Cables Industry SAOG, PK Services, Polycab, Sabic, SLV, System Electrical, Tata Motors, UEM, UMIC, Vega, Vertex, Voltas,

---

what do you mean by mf of energy meter & its formula?

4 Answers  

---

During the main stator winding insulation testing (phase to ground)of 11kv alternator (Lerysomer) i found 0 and resistance with multimeter and found 20 killo ohm while the power cables are connected both end (Generator & VCB). In VCB PT (Potential transformer) are connected. Please any body explain that method of insulation is correct or not? also describe of PT connections

1 Answers   Private,

---

---

what is ELCB?

10 Answers   Wipro,

---

What is OLTC AND RTCC and it's function?

2 Answers   Sterling Wilson,

---

How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav neutral)Thn we go for step down transformer.Our load 10 amps,so we conisder this amps in primary are secondary side

1 Answers  

---

what is meant by moulded case circuit breaker ?

0 Answers   ABB,

---

what is the usage of microcontroller in the panel board?

0 Answers  

---

The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition

0 Answers  

---

why we use post insulators in no ofstacks at substation for supporting equipment ? why we not use single post insulator

3 Answers  

---