Answer / k.prakashchandra

Take current carrying capacity of copper as 2.5A/mm2 and
that of Al as 1.5

Answer / m.stalin

1,1.5,2.5,4,6,10,25,35,70,95,120,180,195,240,300,400 sqmm 3
core UG cables are available in market.as per thump rule in
aluminum cable 1 am p/sqmm. in copper 1.3 amp /sqmm
if you need cable chart pls email your id

mastalinprabu@gmail.com


M.STALIN

What do you mean by ratio correction factor of instrument transformer?

0 Answers  

---

How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?

0 Answers  

---

In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?

0 Answers  

---

In what voltage EHT works(133/132/33/66kv?

3 Answers   Adhunik,

---

How do you convert the lt amps on a transformer to the ht amps?

2 Answers  

---

HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?

0 Answers   TMB,

---

WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.

0 Answers   L&T,

---

Why HRG and LRG used beside transformer, what is the purpose

3 Answers  

---

what are the different types of bus bar used at electrical work at shelter

3 Answers   Aster Teleservices, Costco,

---

May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?

0 Answers  

---

Corona occurs between two transmission wires when they (a) are closely-spaced (b) are widely-spaced (c) have high potential difference (d) carry d.c. power

2 Answers   Power Grid,

---

how can we find thae value of capacitor for single phase motor. what is difference between starting capacitor and running capacitor.

0 Answers  

---