what is purpose of using neutral grounding transformer in
generators??



what is purpose of using neutral grounding transformer in generators??..

Answer / sumanth kumar b

neutral groundig is done for the generator and transformers
because for transformers if any sort of a failure in the
neautral wire then the earthing of ground can act as a
neutral for some time.If neutral is not been used then due to
the neutral wire failure if we use the lighting loads then in
that we generally use any one phase let it be R phase and
neutral y phase act as a neutral so in a single phase two
phase current passes it causes more damage to the loads.that
is why we use neutral grounding

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

what is the highest transmission voltage in india???

49 Answers   Bhel, EIPL, Engineering, Jindal,


different between horse power and break horse power

2 Answers   Allied Group,


what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor

0 Answers  


two 100W/230V bulb are connected in series. what would be the voltage drop across 1 bulb

6 Answers  


why constant voltage transformer should be start without load? and if started then what will happen?

0 Answers  






When we are working on transformer(132\11KV). we are going to isolate the transformer from both HV side and LV side. then we are applying grounding on both side. My question is that we required to isolate the VT which is still connected from secondary side.?

1 Answers  


While connecting the flood light plug on to the 415 V distribution panel,there was spark and the cable got burnt. Three ignitors of the flood light also burnt of. The lamps are of 400 W (total 6 lamps) connected through 1.5 mm2 cable. The plug was immediately removed from the circuit. There was a 30 mA RCD connected and a 250 A MCCB; however both did not trip. What could be the possible reasons for the circuit devices not to trip?Can someone assist please. Additional info if needed can be provided.

2 Answers  


Why we have short circuit the secondary of the transformer

1 Answers  


why we are using the ac supply in domestic purpose, why don't use dc supply.

5 Answers  


acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO

0 Answers  


1 Sq.mm ( Aluminium Cable ) = How much Amphere ( AMP )

4 Answers   Google, TATA,


what are the types of 3-ph. generator protection

2 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)