Answer / badshah

Accident/Incident Report should have a Preliminary &
followup Report. Preliminary Report contains details like
Name of the victim, equipment or an property damage & their
details and Place of Happening, date & time of incident.
Immediate Supervisor or in charge name contact no., Brief
description of the incident happened, Name of any witness.
Check Whether Safety precautions done as per Legal, Company
policy, procedures are followed are not and identify the
causes if required. Check whther Risk Assessment is done
for that activity. All the above points should be
considered in making the report.

Followup report should contain the description of the
accident to be filled by the in charge or supervisor after
investigating the incident and to be reported within say 3
days.. This also caontains the Senior or Managers comments
to avoid the incident.
Followup report will be replied by HSE or higher authority
with recommendations to avoid such incidents...so a
corrective action sheet is also included along with
followup report which will have recommendations from HSe or
higher authority and Action taken for the recommendation
which has to be replied by Manager of the concern or victim.

All officials involved like supervisor, manager, HSE
personnel should sign at respective places in the report.

A time frame to be set for replying for the recommendations
by HSE.

what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.

0 Answers  

---

synchronous motor of 13.5MW having which type protection? and how to set relay?give me relay setting calculation for different protection for this motor assume efficiency,power factor and other term if neccecery

1 Answers  

---

can motors working at parallel operation like D.G set and transformers? It means asking about two motors coupled with same load???

1 Answers  

---

Dear Friends, I have a 500KVA transformer supplying whole factory having 3 phase and single phase mixed loads. Power room has ammeters connected via CTs for individual phase. Now I know that readings shown on meter for each phase say R,Y and B are line currents. But when I want to know the total on transformer do I need to add the currents of all three phases readings shown on meter or value for anyone phase will give me the correct power load on transformer for that point of time. 2. If ammeter shows unbalanced readings for R,Y, B phases say 150, 250 and 300 respectively so can I assume that 150A i.e average of 3 will be the 3phase load currents and remaining will be 1phase currents. Please clarify my doubt.

4 Answers  

---

Can somebody tell me the type and amp of transformer used to implement 600VA UPS? Thanks in advance.

1 Answers  

---

---

What is an ac motor?

0 Answers  

---

how to check regenerative load in drived motor

0 Answers   Hindustan Unilever Limited, NHPC,

---

What is electrical energy ,power?

2 Answers   ABB,

---

the 230 value of voltage which is use in our home . is that value is rms, aerage or peack value of voltage?

5 Answers   L&T,

---

What are the types of Transformer? Name them.

9 Answers   Bhel, HSL, NTPC,

---

what is CT class? depending upon which it is classified?

3 Answers   Siemens,

---

How does a transformer contribute towards the widespread popularity of ac system over dc?

0 Answers  

---