Answer / nahin

yes.
fluorescent bulb works under the principle of scattering of
electron.An incident electron collides with an atom in the
gas. According to the Einstein formula: Kmax=hf+phi,
the kinetic energy depends on the frequency. So, if we
reduce the frequency, the kinetic energy of electrons will
also be reduced and thus the performance will be degraded.

Answer / atulsinghrajput

yes

Answer / saravanan

YES

Answer / dhivagar

no

Answer / srinivas

yes

Answer / s.arul

yes, surely affected the glowing.
flurescent lamp in 50hz supply 20milli second one time
reached in zero position in sine wave (that time light not
glowing) that time is very less. in 25hz supply 40ms one
time reached in zero position that time light not full
brightness compared to 50hz supply.

Why Humming noise originated in Starter motor and how it was generated ?

3 Answers  

what's the meaning of the negative going half cycle in the circuit containing a bulb and a switch in series with a input ac source. i mean what happens in the -ve cycle. the dir. of current changes or any other thing. if dir. changes then why we use fuse in only phase wire.

2 Answers  

What happen when switch yard one pole not tripe when you tripping the breaker

3 Answers   Adani,

Explain the grounding concept adapted in aircrafts?

2 Answers  

WHY STABILIZER SHOULD USED

2 Answers  

how to calculate voltage drop and followed by cable calculation?is there avail in formula?

0 Answers  

without any theoretical calculations, can u approximately tell the current rating of a motor(above 30hp)working at 415VAC.

7 Answers  

Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.

0 Answers  

why we can use 1 to 5V dc

0 Answers  

why select the 3 phase power supply system in electrical system.

3 Answers   RSE, Yamaha,

Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC

0 Answers  

1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.

0 Answers   Wipro,