Answer / birinchi narayan boruah

It depends upon designed parameter of the motor. Generally
All 3 phase Induction motors take starting current 3 to 5
times of the full load current. 200 Amps incomer can be used
for the same but its better if you go for higher rating.

Answer / prashant

P = 1.732VICosA

I = 148A
Starting current of a motor is 1.25 - 1.5% of I so you
should be able to run the motor but it will be preferable
if yu can go for the next higher rating

why effective resistance should be more than static resistance in transmission line?

0 Answers  

---

why VCB are not used in 132KV system(above 33KV system)

6 Answers   Al Ahleia,

---

why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.

0 Answers   Siemens,

---

What is fault.?

2 Answers   AngloGold Ashanti, MNC,

---

What do you mean by cold shinkable cable joint.How it is done.

0 Answers  

---

working method of railway electricl loco in single wire 25000 volt

1 Answers  

---

What do you mean by a voltage transformer?

0 Answers  

---

What is a charge.?

4 Answers  

---

In step down transformer (415/200V),mistakenly secondary side is connected to 415V for some hours, what would be result of this condition?

19 Answers   Essar, GAIL, Vizag Steel,

---

3) How earthing is done? How it measured? Write the method for earthing? How the earth resistance is kept low?

1 Answers   Innovative Energy,

---

why we are using2 wave trap in a feeder?

1 Answers  

---

why there is a high voltage line in multiplication of 11?i.e.- -66kv,11,kv,22kv

4 Answers   Bhel,

---