Answer / ramesh kumar k

Electrically... there is no problem... until the rotor
position disturbs...
but there is a chance for that... as the lower side bearing
will have to bear all the rotor weight.. and that also the
force acting on the bearing will not be in proper
direction... so first the bearings will gets damaged... and
then position of the rotor will be disturbed...so there
willl not be smooth operation of the motor.....

Answer / sameer lingayat

cab be possible but with some foundation modification.
but it is not recommended by motor manufactures as it may
affect motor performance and less motor life.

Answer / brighten

1) For Vertical mounting Motor. Flange type Mounting will
be the best.
2) If the motor is Fractional KW then Mounting is not
matters. if Rating of motor is High it is not possible to
use Horizontal motor as Vertical.

Answer / vishal ingle

I AGREE WITH MR. RAMESH KUMAR.
ELECTRICALLY THERE IS NO PROBLEM
HOWEVER MECHANICAL ASPECTS TO BE CONSIDERED
SUCH AS TYPE OF LOAD, BEARING SPECIFICATIONS,
TYPE & STRENGTH OF FOUNDATIONS.

Answer / rajagopal.d

First we have to check motor is connect which drive pump,
Agitator depand upond frame size ,rpm rating in duty

To check the earth condition (In plug points); the voltage between earth and Neutral is in below 5 volts. Is it correct

6 Answers  

---

How to find out kvar from any particular load capacity give a formula

3 Answers  

---

Differentiate between magnetic field and magnetic flux?

0 Answers  

---

If Two Generators are working parellel in a network and suddenly the field of one Generator get weakened What will happened if there is no reverse power relay fixed in that Generator panel????

7 Answers  

---

tan delta test of current transformer.

3 Answers   NTPC,

---

---

what is LT & HT?

6 Answers  

---

40 HP motor how many square mm size wire use for stator to motor & aluminium wire use ?

1 Answers   SSPL,

---

What is difference between YNyn0 and YNyn ??

0 Answers  

---

hoe to test voltage restrained overcurrent relay?

2 Answers  

---

Dear All, If we have 8No. 11kV cables running underground that are required to supply 20MW to a new development. What is the sustained current in Amps? Please advise.

1 Answers  

---

Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?

0 Answers  

---

difference between cable and conductor?

6 Answers   TransOcean,

---