Answer / chander shekher

AC Ton covered area
generall in designin we take 1tone for every 120 Sq feet of area hence

total ton required= area(sq feet)/120

Answer / biernder singh

AC always rated in tons because it designed on the basis of quantity of "heat removal" from room.quantity of heat is termed in tons means if an AC IS ABLE TO REMOVE 1000 KILO CALORIES in an hour that AC rated as 1 ton.
1 ton= 1000 kilo calories
=4120 kilo joules
=12000BTU(British thermal unit)
if you want to know of the power rating of AC then use it formula given below
1 ton =3.516852 KW .
for example 3 ton
3*3.516852 =10.55KW.

why is the vector group analysis done in transformer tests

28 Answers   K K Rao, Lloyds, Nicco Engineering Services Limited, Qatar Petroleums,

---

Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?

2 Answers  

---

If a contactor need to replace with faulty one. what I want to check?

2 Answers   Bhel,

---

Write the current equation in series RLC circuits.

0 Answers   Agilent, Integreon, ZS Associates,

---

i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors

0 Answers  

---

What is the power plant or power station?

1 Answers  

---

How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.

0 Answers   Allied Group,

---

What is the function of electron gun used in crt?

0 Answers  

---

I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE

0 Answers  

---

Why is the starting current high in dc motor?

0 Answers  

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  

---

Show the schematic arrangement of diesel power station layout and give its principle of operation.

0 Answers  

---