Interested to Buy Any Domain ? << Click Here >> for more details...
Can any horizontally mounted motor be used as vertical?
- 5 Answers
- 22211 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh kumar k
Electrically... there is no problem... until the rotor
position disturbs...
but there is a chance for that... as the lower side bearing
will have to bear all the rotor weight.. and that also the
force acting on the bearing will not be in proper
direction... so first the bearings will gets damaged... and
then position of the rotor will be disturbed...so there
willl not be smooth operation of the motor.....
| Is This Answer Correct ? | 16 Yes | 2 No |
Post New Answer View All Answers
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
Draw the circuit of clapp oscillator?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
A 1F capacitor is charged to 100V initially. A 1H inductor is connected accros the capacitor througha a switch. The current in the circiut when the switch is closed is____
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
How to test IR testing & magnetic balance test
what causes contact chatter when there is no demand on the air conditioning unit?
