60 watts bulb and resistor home heater is connected in
series and 230v is given to the circuit. The heater is
giving some amount of heat. If instant of 60 watts bulb
replace 100 watts bulb what will be the output of the heater?
Answers were Sorted based on User's Feedback
Answer / vinod
output of heater will be more as 100 w bulb has less
reistance copared to 60 w
| Is This Answer Correct ? | 14 Yes | 0 No |
Answer / anil
output of heater will be greater than that of output of bulb
| Is This Answer Correct ? | 4 Yes | 0 No |
Is there any specialised book to refer about fault level calculation both in MV and LV side??
how to calculate cable size in diffrent loads?
how to calculate the neautral earthing conductor size for a 500kva dg set.
Why is the earth fault relay connected to the Yellow Phase?
why capacitor using the induction motor?
how to calculate the no load current in transformer?
What is an Isolation Transformer? Where it will use?
How to Calculate the maximum Demand required for a connected load for a manufacturing Plant
Hi friends. is it possible that SCADA System through RTUs can connect Via PLCC Communication carriers ? thanks
Our transformer capacity is 500kva & voltage ratio is 11kv/433v step down tf.Now i need to know if my input voltage is 10500v and what would be the secondary side voltage i.e output voltage ?
Generally at what power factor the electronic equipments like computer, TV, EPABX etc.,operates. Please tell me.
why diesel tank is earthed
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)